[OpendTect_Users] 2D horizon export is missing lines

[Neil Peterson]

I had the same problem. I exported them individually then pasted them into a single las file that I then used for gridding.


Best Regards,

Neil Peterson | Senior Geologist | Gradient Resources Inc | 9670 Gateway Dr. Suite 200, Reno NV 89521 | ph: 775-284-8842 | cell: 775-217-2629 | email: neil.peterson at gradient.com<mailto:neil.peterson at gradient.com>



On Oct 29, 2012, at 8:53 PM, "Randy Hunt" <rl_hunt at yahoo.com<mailto:rl_hunt at yahoo.com>> wrote:

Hi all, I am exporting a 2D horizon so I can grid it in Surfer, but I am missing some of my lines in the output.   It appears that I only get one line set at a time in the export file, and I don't see a way to select the other line set for export.   Does anybody know how to solve this?

Your thoughts much appreciated.

Randall Hunt
Pittsburgh, PA
_______________________________________________
Users mailing list
Users at opendtect.org<mailto:Users at opendtect.org>
http://www.opendtect.org/mailman/listinfo/users

You receive this mail because you are listed on users at opendtect.org<mailto:users at opendtect.org> To unsubscribe please go to http://lists.opendtect.org/mailman/options/users . If you encounter any problems, please contact support at opendtect.org<mailto:support at opendtect.org> .
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.opendtect.org/pipermail/users/attachments/20121030/eed6da2f/attachment.html>